Not an amanda tape

From The Open Source Backup Wiki (Amanda, MySQL Backup, BackupPC)

Jump to: navigation, search

This article is a part of the Troubleshooting collection.

Problem

An error message from Amanda:

... not an amanda tape

Solution

Amanda requires you to label tapes before it uses them. Run amlabel(8) in order to label a tape.

You may also be able to use label_new_tapes (autolabel as of version 3.1) in amanda.conf(5) to automatically label tapes.

If, even after labeling a tape, amcheck(8) still complains about it, make sure the regular expression specified via labelstr in amanda.conf(5) matches the label you have specified, and check whether you have configured non-rewinding tape devices for Amanda to use. For example, on Linux use /dev/nrst0 instead of /dev/rst0, or /dev/rmt/0bn instead of /dev/rmt/0b. The `n' stands for non-rewinding.

If you have labeled any tapes using the rewinding device configuration, you may have to label them again (see Discussion).

Credits

This text was originally contributed to the AMANDA-FAQ-O-Matic by gyles19@visi.com.

Personal tools