amdump — back up all disks in an Amanda configuration
amdump
config
[--no-taper
] [
host
[disk
...]
...] [-o
configoption
...]
Amdump is the main interface to the Amanda backup process. It loads the specified configuration and attempts to back up every disk specified by the disklist(5). Amdump is normally run by cron.
The command optionally takes a set of DLE specifications (see amanda-match(7)) to narrow the DLEs that will be dumped. All disks are dumped if no expressions are given.
If a file named hold
exists in the configuration directory,
amdump
will wait until it is removed before starting the backups.
This allows scheduled backups to be delayed when circumstances warrant, for example,
if the tape device is being used for some other purpose.
While waiting,
amdump
checks for the hold file every minute.
In some cases it is desirable to dump all Amanda clients to holding disk
without writing anything to storage media. The --no-taper
option instructs Amanda to not start the taper, and thus enter degraded mode
immediately.
See the amanda(8) man page for more details about Amanda.
host
[disk
]*Specify the host and disk on which the command will work -- see the description of DLE specifications in amanda-match(7).
-o configoption
See the "CONFIGURATION OVERRIDE" section in amanda(8).
Here is a typical crontab entry. It runs amdump every weeknight at 1 a.m. as user bin:
0 1 * * 1-5 bin /usr/local/sbin/amdump daily
Please see the crontab(5) or crontab(1) manual page for the correct crontab format for your system.
The "hold" file exists and amdump is waiting for it to be removed before starting backups.
Amdump detected another amdump or amflush running, or the remains of a previous incomplete amdump or amflush run. This run is terminated. If the problem is caused by the remains of a previous run, you must execute amcleanup(8) and then rerun amdump.
0 = success 1 = error 2 = a dle give strange message 4 = a dle failed 8 = Don't know the status of a dle (RESULT_MISSING in the report) 16 = tape error or no more tape
amanda(8), amcheck(8), amcleanup(8), amrestore(8), amflush(8), cron(8), amanda-match(7)
The Amanda Wiki: http://wiki.zmanda.com/
This manual page was written by
and .