amvault — Copy Amanda dumps from one volume to another
configoption...] [ --dry-run | -n ] [ --quiet | -q ] [--fulls-only] [--latest-fulls] [--incrs-only] [--exact-match] [--export] [--no-interactivity] [
This application is not yet in its final form, and is subject to major revision in subsequent versions of Amanda. Backward compatibility is not guaranteed.
Note that Amanda restore/recover operations will request tertiary media by label when dumpfiles are not found on secondary media, but there is no provision to automatically fetch such media from a different changer
Feedback on and patches to this application are invited and encouraged!
Amvault is conceptually equivalent to "amfetchdump | taper". That is, it reads specified dumps from secondary media and re-writes them on tertiary media.
Amvault Copies data on
src-storage from the run with
src-timestamp onto volumes using the storage
The dumps to be read from secondary media can be specified by any
combination of dump specifications,
--src-timestamp. At least one must be specified, lest
amvault attempt to vault all dumps in the catalog. See amanda-match(7) for more information on dump
Note that the datestamp given in the dumpspec is the
dump datestamp - the run in which the backup was taken
on the Amanda client. The
--src-timestamp, on the other
hand, is the write timestamp - the run in which the
dump was written to secondary media. The latter option facilitates
duplicating the results of an entire backup run, including any dumps that
might have been flushed from holding disk.
The amvault-storage is the default destination storage.
If amanda.conf(5) contains the new part-size splitting parameters, then amvault will use them without any additional configuration. However, if the configuration still uses the old splitting parameters (tape_splitsize, split_diskbuffer, and fallback_splitsize), then amvault will need some additional configuration in order to properly split dumps to tertiary media. To do so, specify a new tapetype in amanda.conf(5), say "TERTIARY", and set the part-size and other appropriate parameters there. Then reference that tapetype in the amvault invocation:
amvault -otapetype=TERTIARY ...
Dumps are written to that storage
Cause amvault to print the dumps it would vault, but not actually perform any vaulting operations.
The host and disk are parsed as exact values
Cause amvault to attempt to move completed tertiary volumes to import/export slots, where they can be more easily removed by an operator.
Only full (level-0) dumps are copied.
Only incremental (level > 0) dumps are copied.
The latest full of every DLE in the disklist that do not have the skip strategy.
Disable interactivity if a source volume is not found.
Eliminate non-error messages, and is useful when running amvault from cron.
Dumps are read only from that storage
Specifies the timestamps in the format 'YYYYMMDDHHMMSS' of the run to vault, can be "latest", then the most recent amdump or amflush run will be used.
See the "CONFIGURATION OVERRIDE" section in amanda(8).
Vault all dump written to tape in the latest amdump or amflush run:
$ amvault --src-timestamps latest CONF
Vault all dump written on the run of December 7 2011 12:13:14 :
$ amvault --src-timestamps 20111207121314 CONF
Vault all dump dumped on any run of December 7 2011:
$ amvault CONF \* \* 20111207
This manual page was written by.